Can you run a screwdriver? If the answer is yes, you can install your coat rack. All tool boxes have the necessary tools already in it to mount a coat rack. To get started one needs to decide where you have a call for a coat rack, customarily located by an exit door. When the special part fastener position is has been resolved you will wish to resolve the elevation starting from the floor to put up your coat hooks. Common mounting heights are more or less around 40 inches for children to utilize and more or less around 62 inches for adult use. The finished elevation is up to you depending on your requirements. Find the around the center of your chosen spot of your coat rack and measure from the floor, if you are troubled about marking on the wall or are uncertain of the spot position a spot of removable tape on the wall and mark on the masking tape. This precludes marking directly on the wall. Using your level, again you can use a laser level situate the level or laser on your mark and hold it horizontal and mark the left and right ends of the spot of the coat rack. If a laser level or laser is not accessible you can obtain a piece of removable tape just about the length of the coat hook and position it on the wall level, stand back a short distance and thoroughly look at the removable tape does it look horizontal? if not adjust until you have a nice horizontal removable tape line. Once you get a nice parallel removable tape line to show you in the installing of your coat rack.

You will need to locate the studs. The piece of removable tape that was installed prior is the perfect place to mark the place of each stud. A stud finder is the accustomed apparatus used for fining the position of the studs, a stud finder sells for just about $15.00. If a stud finder is not accessible look for an electrical outlet, these are commonly affixed to a stud. Wall studs are located every 16". We are now on the final stretch if your coat rack uses a straight through installation system, position your coat rack along the earlier located level mark situated on the removable tape. Employ the installation screws put it in the installation hole and mark the wall, duplicate this for all installation holes. If your coat rack involves a key-hole installation system you will be required to measure the distance between the holes and move the dimensions to the removable tape. Once the holes are marked you need to pre-drill the fastener key-holes, make sure the screws and select a twist drill bit smaller than the fastener and drill the holes. If you are installing the coat rack with the trough hole installation technique locate the coat rack on the level line and drilled holes put in the installation screws and tighten evenly. If you are employing the key-hole installation technique put in the screws run fasteners until the head of the screws extends out just about 3/8 of an inch from the wall, put the coat rack over the screws and slide down. You’re new coat rack is now ready for coats.